Sculptor - Painter - Printmaker
Wind Jammer by Richard Arfsten
Wind Jammer would make a spectacular sculpture for a yacht club or a marina. I can almost feel the the wind and some ocean spray.
This is a maquette to measure off of to build a large version of this design. It can be shipped anywhere and used to build close to where it will be placed. It is designed to be built with flat sheet metal. It is a welded form which is much less costly to construct than a form cast in a foundry. It can be designed to bolt together on site so a very large piece can be made for a relatively modest sum.
It would also work as a desk top sculpture. It will come with a thick stone base. The top will be polished and the sides will be rough cut.
If you would like to buy the enlargement rights please contact me.
This is a maquette to measure off of to build a large version of this design. It can be shipped anywhere and used to build close to where it will be placed. It is designed to be built with flat sheet metal. It is a welded form which is much less costly to construct than a form cast in a foundry. It can be designed to bolt together on site so a very large piece can be made for a relatively modest sum.
It would also work as a desk top sculpture. It will come with a thick stone base. The top will be polished and the sides will be rough cut.
If you would like to buy the enlargement rights please contact me.